Slaughter

United Kingdom

See product on hipot.com

The 2935 allows manufacturers to perform AC Hipot, and DC Hipot tests in a single instrument. This Electrical Safety Tester features a 5 KV AC Hipot test with 12 mA of test current and a 6 KV DC Hipot test with 5 mA of test current. Equipped with the latest technology and features the 2935 is the right solution for a Electrical Safety testing applications that require both AC and DC Hipot test voltage. 1. Tamper proof front panel controls This makes it possible to limit user access to the setup screens so that only authorized personnel can change test parameters. 2.

Test setup memories The operator can store and recall test setups, thus eliminating the need to re-enter setup information. There are five memory locations available. 3. Low-current sense The low current sense feature monitors the minimum level of current flow, thus ensuring that the DUT is properly connected and that the Hipot test is being performed. 4. Simple Menu Control All parameters for the setups can be adjusted through a simple menu driven program. The easy to follow setup screens ensure that the operator correctly sets up all test parameters. 5. Electronic dwell settings The electronic dwell control helps keep test results consistent by ensuring that the test duration is the same for each product tested. 6. Electronic ramping Electronic ramping provides a gradual and timed method to increase output voltage to the DUT, minimizing any damage from quickly over-applying high voltage to sensitive DUTs. 7. Front panel LCD A front panel LCD allows the operator to monitor the test. The display holds the results after a test item failure so that the operator can easily review the test results. Indications of high fail and continuity failure are clearly displayed. 8. No load setup of trip current and output voltage This provides the operator with an easy and safe way to set trip currents and output voltages since parameters are set without the high voltage present. 9. Storage of test program The 2935 powers-up with the same parameters that were used during the last test to avoid operator set-up errors. 10. Built-in Continuity test mode The 2935 meets ground continuity test requirements called out by UL and other safety agencies. 11. Output voltage fine adjustment To make the 2935 usable in all types of applications, the operator can manually bring the voltage up or down in 10 volt increments by simply pressing the up and down arrow keys. This makes it very easy to adjust the output voltage even while the instrument is in the dwell mode so you can analyze test results at different voltages. 12. Software calibration control The 2935 is calibrated through the front panel keypad. All calibration information is stored in non-volatile memory. This allows the instrument to be completely calibrated without removing any covers and exposing the technician to hazardous voltages. 13. Current monitoring The LCD display allows monitoring of current down to 100 microamps AC and 20 microamps DC. This allows the 2935 to be used even when test requirements only allow a very low level of acceptable leakage current. 14. Line and load regulation This system maintains the output voltage to within 1% from no load to full load and over the line voltage range to ensure that test results remain consistent and within safety agency requirements. 15. PLC remote inputs and outputs The standard 9- pin interfaces provide outputs for Pass, Fail, and Test in Process. Inputs include Test and Reset. This gives the user all the basic remotes required to configure the Hipot through simple PLC relay control. 16. Flashing high voltage indicator A flashing LED located directly over the high voltage terminal clearly indicates when high voltage is active to provide maximum operator safety.
Save this product