Magnum Venus Plastech Ltd

Address :

MTC, Chilsworthy Beam, Gunnislake,
PL18 9AT - Cornwall
United Kingdom
Tél. : 01822 832621

See product on plastech.co.uk

Using the pressure pot principle, pre-mixed resin and catalyst are drawn under vacuum into the machines homogeniser, actively degassed and then dispensed under pressure into the mould cavity. Standard 3 & 6 litre capacity homogenisers are complimented by ‘special order’ sizes, ranging from 0.3 to 30 litre. Can inject as little as a cupful of pre-mixed material. The homogeneous mixing will eliminate cure profile distortions caused by inaccurate catalysation. Injection pressure is controllable. Specification Incoming air, vacuum level & Injection pressure gauges.

s. Injection indicator with injection pressure regulator. Internal air driven vacuum generator. Remote thumb control switch. Operates from 0.7lt/sec (1.5cfm) compressed air supply at 6 bar(90psi). Non moving part operation provides low maintenance service.
Save this product