Enrico Pesatori

United Kingdom

See product on pesatori.com

MULTIFUNCTION APPLIANCE FOR ELECTRIC SAFETY TESTS EDO 4 ENABLES TO CARRY OUT TESTS FOR: -Dielectric strength; -Continuity of the equipotential circuit; -Insulation resistance; -Residual voltage in accordance with the directions of the IEC roduct rules and with the EC directives. EN 1180-1/2, EN 61180-1/2 (CEI 42-9/10) Concerning high voltage testing techniques for low voltage appliances. EN 60439-1 (CEI 17-13/1) Concerning electric boards, type AS and ANS. CEI 23-51 Concerning electric boards for domestic use and similar. EN 60204-1 (CEI

44-5) Concerning appliances electric equipment EDO 4 is totally microprocessor run, thus enabling to get all the measures in true effective value (TRUE RMS). Every command to be given to EDO4, except for high voltage regulation during the dielectric strength test, goes through the 8 buttons of the front switchboard only. With EDO4 microprocessor it is possible to switch scale automatically (if provided for), to support the precision of measurements with a software and to set measurements either with a software or with a hardware. EDO4 can also store 2000 tests already done. It is possible to print stored results by linking a parallel printer to the connector already present on the appliance, even after it has been switched off. Remote control allows EDO4 programming through PLC or by any external keyboard. EDO4 allows a PC to be linked through a serial gate RS232. The employed display is of an alphanumeric kind, backlighted with 4 lines and 40 columns. The following table shows all the feasible parameters to input and the precision of measurements.
Save this product