Selection of 70 products among
123
ELECTRICAL CABLES - TRI-RATED CABLE
Eland Product Group: A2TApplication: Tri-rated Cable panel wiring is a high temperature, flame retardant cable designed for use in the switch control, relay and instrumentation panels of power
switchgear and for purposes such as internal connectors in rectifier equipment, motor starters and controllers. Tri-rated Cable is sometimes referred to as BS6231 Cable or Panel Wire.Standards: BS6231 Type CK UL Subj.758 CSA c.22.2 No. 127 (only applicable for sizes up to 120mm²) Conductor: Class 5 flexible plain copper conductors to BS EN 60228:2005 (previously BS6360)Insulation: PVC (Polyvinyl Chloride) Insulation Colour: Black, Red, Blue, Yellow, Green/Yellow, Grey,Brown, Orange, White, Violet, Green, Pink, Light Blue, Dark BlueVoltage Rating: BS6231: 600/1000V UL, CSA: 600VTemperature Rating: BS6231: 90°C (105°C for 15,000 hours) UL, CSA: 105°CMinimum Bending Radius: 6 x overall diameterNote: Cables above 120mm² in size are referred to as Bi-rated since the CSA standard applies only to sizes up to and including 120mm²
>>>
View the product on eland.co.uk
Eland Cables
AEROSTAT CABLE
Tethered Aerostats are unmanned non rigid lighter than air cehicles sometimes referred to as 'blimps'. These Aerostats remain anchored to the ground by a thether cable. This tether cable provides
electrical power to the platforms systems, radar, infrared , CCTV, etc via fibre optics (fiber optics). The tether cable can also act as the main tensile rope, this involves the use of aramid fibres which act as the strength member enabling the cable to withstand snatch loads of several tonnes.
The tethered aerostat (TA) consists of the envelope with the ballow, the payload suspended by rope and rigging. The payload would include navigational equipment, control and emergency power and lightning discharge protector. Working altitudes can vary from 1000-5000 meters with payout speeds of up to 180 meters per minute.
The cable construction uses Fibre Optics (Fiber Optics) and conductor cores and coaxials, these elements are wrapped in aramid bibres like kevlar (tm) or Twaron that acts as the strength member normally rated 4-5 times the safety margin with limited elongation of less than 3%. The entire package is extruded with a waterproof protective material such as polyurethane. The cable diameters are between 12-19mm diameter.
The strength element aramid fibre is terminated in a lightweight eye thimble to a padeye and the conductor elements pig tailed out the dise of the tether to special waterproof connectors. All these components can be made in delrin peek or aluminium for reduced weight implications.
Objective design for Aerostat cables and important characteristics are material stiffness and strength to weight ratio (B/D ratio). The diameter of the tether has to be as small as possible to reduce or limit the aerodynamic drag.
>>>
View the product on hydrohouse.co.uk
HYDROBOND ENGINEERING LTD
ELECTRICAL CABLES - ALARM CABLE
Eland Product Group: A3AApplication: Flexible alarm cable used for the wiring of burglar alarms and other low voltage circuits.Standards: BS4737 Conductor: Class 2 stranded tinned copper
conductorFiller: PVC (Polyvinyl Chloride) dummy coreInsulation: PVC (Polyvinyl Chloride) Sheath: PVC (Polyvinyl Chloride)Sheath Colour: WhiteVoltage Rating: 300VTemperature Rating: -10ºC to +70ºC Minimum Bending Radius: 12 x overall diameterConductor Identification: 4 Cores: Red, Blue, Yellow, Black, 6 Cores: Red, Blue, Yellow, Black, Green, White 8 Cores: Green, Yellow, White, Black, Blue, Red, Orange, Brown 12 Cores: Red, Blue, Yellow, Black, Green, White, Orange, Brown, Grey, Light Blue, Pink, Violet
>>>
View the product on eland.co.uk
Eland Cables
RS-232 FOIL SCREENED MULTIPAIRS 24AWG CABLE
Widely used for computers, point of sale, control systems, and RS232 applications. This is a general purpose overall screened twisted paired cable.
Tinned copper conductor 24(7) AWG, 0.22 mm², PVC
insulation, colour chart 3. Twisted into pairs, overall aluminium/polyester foil screen, tinned copper drain wire (24AWG), PVC sheath on standard cables. UL Style 2464 300V 80°C. Capacitance: core to core 98pF/m, core to screen 164pF/m.
Armoured (SWA) versions are available on quantities as low as 100 metres.
>>>
View the product on fsc-global.com
FS Cables (Flexible Specialist Cables)
ELECTRICAL CABLES - COAXIAL RG/URM/COMPOSITE CABLE
Eland Product Group: A7EApplication: Coaxial cable used for low power video and video signal connections. Conductor: RG11: TCW (Tinned Copper Wire) RG58: TCW (Tinned Copper Wire) RG59:
CCS (Copper Clad Steel) RG179: TCW (Tinned Copper Wire) RG213 PVC: PCW (Plain Copper Wire) RG213 LSZH: PCW (Plain Copper Wire) URM67: PCW (Plain Copper Wire) URM70: PCW (Plain Copper Wire) 75 Ohm Coax + 1Pair: PCW (Plain Copper Wire) + TCW (Tinned Copper Wire) 75 Ohm Coax + 1Pair: PCW (Plain Copper Wire) + TCW (Tinned Copper Wire)Dialectric: RG11: PE (Polyethylene) RG58: PE (Polyethylene) RG59: PE (Polyethylene) RG179: FPE (Foam Polyethylene) RG213 PVC: PE (Polyethylene) RG213 LSZH: PE (Polyethylene) URM67: PE (Polyethylene) URM70: PE (Polyethylene) 75 Ohm Coax + 1Pair: PE (Polyethylene) + PVC (Polyvinyl Chloride) 75 Ohm Coax + 1Pair: PE (Polyethylene) + LSF (Low Smoke and Fume)Braiding: Bare copper braidSheath: RG11: PE (Polyethylene) RG58: PE (Polyethylene) RG59: PE (Polyethylene) RG179: FPE (Foam Polyethylene) RG213 PVC: PE (Polyethylene) RG213 LSZH: PE (Polyethylene) URM67: PE (Polyethylene) URM70: PE (Polyethylene) 75 Ohm Coax + 1Pair: PE (Polyethylene) + PVC (Polyvinyl Chloride) 75 Ohm Coax + 1Pair: PE (Polyethylene) + LSF (Low Smoke and Fume)Colour: Black URM70: Black or WhiteVoltage Rating: 30VTemperature Rating: 60ºC
>>>
View the product on eland.co.uk
Eland Cables
FIBRE OPTIC CABLE
Hydro Group offer a range of different fibre optic (fiber optic) options including single mode, multimode, tight buffered, loose tube, steel tube, plastic tube and ruggedized.
Loose Tube Fibre
Optic (Fiber Optic)
Optical fibre enclosed within a plastic tube with or without gel and aramid fibre suitable for both horizontal and vertical cable applications, each tube can accommodate several fibres.
Tight Buffered Fibre Optic (Fiber Optic)
Similar to loose tube with aramid fibre which provides a high strength, crush resistant component suitable for long vertical spans.
Metal Tube Fibre Optic (Fiber Optic)
Stainless tube encased fibres which can be hermitically sealed, less flexible than plastic tubes it however gives greater physical protection and higher working depth pressures can be obtained.
Ruggedized Applications
The fibre optic is protected in an armour cable strength member, with an outer jacket of hytrel or polyurethane can be used for underwater sensors and sonars, video, telemetry, rov controls in shallow and deep water, aerial camera tethers, thiermistor cables, seismic, sowobuoys and range cables.
>>>
View the product on hydrohouse.co.uk
HYDROBOND ENGINEERING LTD
DYNAMIC FLOW LINE CONTROL CABLE
A dynamic flow line control cable or umbilical is designed to hang in a centenary form between a fixed structure or wellhead platform (WHP) and a floating structure (FPSO). This type of umbilical is
normally low in weight with either contra helical armour or Aramid fibre to endure axial loading. This dynamic flowing cable would normally incorporate power conductors, instrumental and fibre optics (fiber optic) for high data transmission.
Throughout the entire length of the control cable the armour or aramid fibres functions as a load bearing member. The strength members are utilised to secure the umbilical to each installation via a hang off device using flanges, fixing nuts and bolts, bend stiffeners or bend restrictors are installed to protect the cable at vulnerable interfaces. The power cores are rated 0.6/1 Kv IEC – 60332-3-22 CAT A, insulation is normally cross linked polyethelene or RPE. All jacket material is low smoke halogen free thermoset oil resistant compound. The design life of the cable will be at least 10 years and stable when hanging in water.
Fibre Optics (Fiber Optics) are constructed with tight buffered, individual fibre reinforced with aramid yarn. The outer jacket is low smoke halogen-free. Termination of the dynamic cable is via splitter junction boxes with suitable connectors or hard wired for locating in a Zone 1, Gas Group 114, Temp Class T3. Dynamic flowing cables are manufactured to ISO 13628-5 (API 17E) , LRS, DNV, ABS.
>>>
View the product on hydrohouse.co.uk
HYDROBOND ENGINEERING LTD
