APLEI

United Kingdom

See product on aplei.com

UTILIZATION This box has been manufactured to contain the necessary elements to make it possible the automatic water meter reading from outside with no need to go into the buildings. MATERIAL AND DIMENSIONS Box and cover are manufactured in aluminium alloy. 85x85x85. SURFACE FINISH Coated with grey epoxi polyester powder (similar to 7042 RAL) with coarse texture, made by electrostatic projection and dry into an oven to 180-200ºC.To obtain a perfect degreasing and absolute absence of dirt and dust, a pre-treatment is carried out before the surface finish, which consists

s of a neutral-type degreasing followed by a non-chromic conversion to aluminium (i.e. no damage to the enviroment), finished whith a dry to 80ºC. CLOSURE By means of a stainless steel closure system with a male standardised triangular head of 7 mm. WATERTIGHTESS It is guaranteed by means of four screws that press the supporting plate against a neoprene gasket.This allows a degree of protection of IP-65 according to UNE 20324, CEI 529 and EN 60529. INSTALLATION Due to its cylindrical base its placing in the wall is easy whether salient or embedded, as it is necessary just to make a hole in the wall. Installation shall be made near the building entrance according to the water supplier requirements. Plaster mortars must not be used. SUPPLY The box contains a Jack type female stereo connector of ¼1/4" (Ø 6,35mm) with its corresponding electronic plate (with two electrical terminals and a phone connector), being able to manage the reading of up to 50 meters. ARRANGEMENT 1. Supporting plate. 2. Type Jack connector and plate. 3. Axles working as hinges. 4. Spring. 5. Sealing triangular-headed screw. 6.Watertightness gasket. 7.Wall pin that guarantees watertightness with the inlet tube.
Save this product